Symptom: Bad welds or low air volume
Wiring Instructions Please consider the following when connecting a plug to your UNIROOF:
Connecting a twist-lock plug:
Please consider the following when making an extension cord for your UNIROOF:
Machine is not running straight
Note: The blower motor is 3-phase. Make sure that the phases are connected so that it is blowing forwards, not backwards, or the heat of the element will damage the parts behind the element. See below for installation instructions:
Symptom: After heating, tool will not cool down completely (VULCAN E only)
Warming up the WELDMAX before use:
Changing the Welding Shoe:
Cool Down of WELDMAX after use:
Recommended Air and Plast Settings:
Symptom: Display arrives at desired temperature but measured temperature is more than 30C lower than the set temperature
|