Leister Canada
  • Home
  • Equipment
    • All Equipment >
      • Air Heaters
      • Automatic Equipment
      • Blowers
      • Extrusion Welders
      • Hot Air Blowers
      • Hot Air Hand Tools
      • Testing Equipment
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing & Decking
  • Services
    • Product Selection Help
    • Engineering Help
    • Installation Support
    • Product Training
    • Product Service
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Operating Manuals
    • Tech Tips
    • Whitepapers
  • About Us
  • Contact
    • Contact Us
    • Find a Distributor
  • Français

VULCAN Tech Tips

11/24/2016

 
Note: The blower motor is 3-phase. Make sure that the phases are connected so that it is blowing forwards, not backwards, or the heat of the element will damage the parts behind the element. See below for installation instructions:
  • Connect the 3 phases
  • Power it up just long enough to start the motor, and disconnect the power
  • Watch the fan at the air intake, below the red knob. As the blower slows to a stop, check that the fan is turning clockwise.
  • If the blower is turning counter-clockwise, disconnect any two of the three phases and switch them (so that 1-2-3 becomes 2-1-3 or 1-3-2 or 3-2-1)
  • Repeat step 1 to 3. 

After heating the VULCAN, always run it cold for 10 minutes before turning it off. Otherwise the element and parts behind the element may be damaged. 

Symptom:  After heating, tool will not cool down completely (VULCAN E only)
  • Leister is aware of this and there is no solution at this time.  If the surrounding air temperature is cold the VULCAN E will cool down completely, but in warmer surrounding temperatures the VULCAN E will not cool lower than 70C.  Turning off the VULCAN at this temperature will not harm it, as long as the air intake is not blocked.

Comments are closed.
STANMECH Technologies Inc. 
944 Zelco Drive Burlington ON L7L 4Y3 | 1-888-438-6324 | 
info@stanmech.com
Terms of Use    Privacy    Terms and Conditions of Sale   Warranty Policy
Français

Proud Member of:
Picture
Industrial Fabrics Association International
Picture
International Association of Geosynthetic Installers
Picture
​Authorized by the Association of Professional Engineers of Ontario to offer professional engineering services. 
  • Home
  • Equipment
    • All Equipment >
      • Air Heaters
      • Automatic Equipment
      • Blowers
      • Extrusion Welders
      • Hot Air Blowers
      • Hot Air Hand Tools
      • Testing Equipment
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing & Decking
  • Services
    • Product Selection Help
    • Engineering Help
    • Installation Support
    • Product Training
    • Product Service
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Operating Manuals
    • Tech Tips
    • Whitepapers
  • About Us
  • Contact
    • Contact Us
    • Find a Distributor
  • Français