Symptom: Bad welds or low air volume
Tool is not picking up debris or blowing smoke
Blade recommendations:
The HOTWIND must be supplied with cool clean air or used with a filter
SARNAMATIC 661
SARNAMATIC 641MC
Changing the element in a TRIAC.
Carry the TRIAC by the handle, not by the cord.
If the filter at the back of the handle is plugged, air cannot flow through the tool.
When changing motor brushes, clean the brush holders with a cotton swab and contact cleaner.
Symptom: Bad welds or low air volume
Symptom: Error 100 after turning the heat on
Symptom: Bad welds or low air volume
Wiring Instructions Connecting a plug:
Please consider the following when making an extension cord for your UNIPLAN:
|