Leister Canada
  • Home
  • Equipment
    • All Equipment >
      • Air Heaters
      • Automatic Equipment
      • Blowers
      • Extrusion Welders
      • Hot Air Blowers
      • Hot Air Hand Tools
      • Testing Equipment
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing & Decking
  • Services
    • Product Selection Help
    • Engineering Help
    • Installation Support
    • Product Training
    • Product Service
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Operating Manuals
    • Tech Tips
    • Whitepapers
  • About Us
  • Contact
    • Contact Us
    • Find a Distributor
  • Français

VARIANT T1 Tech Tips

11/28/2016

 
Machine is not running straight
  • Refer to page 35 of the operating manual and follow the directions given under "Hot-air welding machine moves away from the weld". Adjusting the fine track adjustment lever clockwise adjusts the tracking to the right, and counter-clockwise adjusts it to the left. A test weld must be completed to verify that the tracking is adjusted properly, running the machine without material will not test this properly.
Wiring Instructions
Please consider the following when connecting a new plug to your VARIANT T1:
  • You must use 20 Amp or higher twist-lock plug
  • The VARIANT T1 is single phase
  • When using a generator make sure the plug is wired for A/C

Connecting a twist-lock plug:
  • Connect the green wire to the pin with the bent tab
  • Connect the white wire to one of the pins directly left or right of the bent tab
  • Connect the black wire to the other pin directly left or right of the bent tab
  • If using a 4 prong plug, leave the red wire and the pin opposite the one with the bent tab disconnected

Please consider the following when making an extension cord for your VARIANT T1:
  • Use a 10 Gauge or thicker cable if you plan to make a 100 ft or longer extension cord
  • If you wish to use a 4 wire cable, leave the red wire and the pin opposite the one with the bent tab disconnected

Generator Instructions:
  • Starting procedure:
    1. Switch on the generator
    2. Switch on the VARIANT T1
  • Shut-down procedure:
    1. Switch off the VARIANT T1
    2. Switch off the generator

Comments are closed.
STANMECH Technologies Inc. 
944 Zelco Drive Burlington ON L7L 4Y3 | 1-888-438-6324 | 
info@stanmech.com
Terms of Use    Privacy    Terms and Conditions of Sale   Warranty Policy
Français

Proud Member of:
Picture
Industrial Fabrics Association International
Picture
International Association of Geosynthetic Installers
Picture
​Authorized by the Association of Professional Engineers of Ontario to offer professional engineering services. 
  • Home
  • Equipment
    • All Equipment >
      • Air Heaters
      • Automatic Equipment
      • Blowers
      • Extrusion Welders
      • Hot Air Blowers
      • Hot Air Hand Tools
      • Testing Equipment
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing & Decking
  • Services
    • Product Selection Help
    • Engineering Help
    • Installation Support
    • Product Training
    • Product Service
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Operating Manuals
    • Tech Tips
    • Whitepapers
  • About Us
  • Contact
    • Contact Us
    • Find a Distributor
  • Français