Leister Canada
  • Home
  • Equipment
    • All Equipment >
      • Air Heaters
      • Automatic Equipment
      • Blowers
      • Extrusion Welders
      • Hot Air Blowers
      • Hot Air Hand Tools
      • Testing Equipment
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing & Decking
  • Services
    • Product Selection Help
    • Engineering Help
    • Installation Support
    • Product Training
    • Product Service
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Operating Manuals
    • Tech Tips
    • Whitepapers
  • About Us
  • Contact
    • Contact Us
    • Find a Distributor
  • Français

How to Check and Correct the Nozzle Position on a VARIMAT

11/25/2016

 
Picture
  • Check that the nozzle is clear of membrane residue. If there is any, heat the VARIMAT and clean using a wire brush.  Cool down the VARIMAT and shut it off.
  • Check the nozzle angle. With the VARIMAT on a flat surface, check that the small end of the nozzle opening is the only point touching the surface, with the rest of the opening and the bottom surface less than 1mm above it.
Picture
  • For a VARIMAT V2 the end of the nozzle should be 40 to 44 mm from the drive tire’s point of contact with the membrane. The wide end of the nozzle opening should be 1 to 2 mm outside of the drive tire.
  • If the nozzle position is wrong, loosen the two slotted screws holding down the guide bar that the Electron heater slides on and move the guide bar. Tighten the slotted screws and recheck the nozzle position.
Picture
  • For a VARIMAT and VARIMAT V, the end of the nozzle should be 40 to 50 mm from the drive tire’s point of contact with the membrane. The wide end of the nozzle opening should be 1 to 2 mm outside of the drive tire. 
  • If the nozzle position is wrong, loosen the two slotted screws holding down the guide bar that the Electron heater slides on and move the guide bar. Tighten the slotted screws and recheck the nozzle position.
​Have questions? Contact us at info@stanmech.com or 905-631-6161 for help.

Comments are closed.
STANMECH Technologies Inc. 
944 Zelco Drive Burlington ON L7L 4Y3 | 1-888-438-6324 | 
info@stanmech.com
Terms of Use    Privacy    Terms and Conditions of Sale   Warranty Policy
Français

Proud Member of:
Picture
Industrial Fabrics Association International
Picture
International Association of Geosynthetic Installers
Picture
​Authorized by the Association of Professional Engineers of Ontario to offer professional engineering services. 
  • Home
  • Equipment
    • All Equipment >
      • Air Heaters
      • Automatic Equipment
      • Blowers
      • Extrusion Welders
      • Hot Air Blowers
      • Hot Air Hand Tools
      • Testing Equipment
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing & Decking
  • Services
    • Product Selection Help
    • Engineering Help
    • Installation Support
    • Product Training
    • Product Service
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Operating Manuals
    • Tech Tips
    • Whitepapers
  • About Us
  • Contact
    • Contact Us
    • Find a Distributor
  • Français