Leister Canada
  • Home
  • Equipment
    • All Equipment >
      • Air Heaters
      • Automatic Equipment
      • Blowers
      • Extrusion Welders
      • Hot Air Blowers
      • Hot Air Hand Tools
      • Testing Equipment
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing & Decking
  • Services
    • Product Selection Help
    • Engineering Help
    • Installation Support
    • Product Training
    • Product Service
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Operating Manuals
    • Tech Tips
    • Whitepapers
  • About Us
  • Contact
    • Contact Us
    • Find a Distributor
  • Français

Wiring Instructions for 230V COMET, UNIDRIVE 500, UNIFLOOR 300/500, and UNIPLAN 300/500

11/12/2021

 
Plug specifications:
  • 250 Volt; 15+ Amp; 2-pole; 3-wire; grounding; twist-lock
  • Example: Hubbell HBL 4570CCN
  • This tool is single phase

When installing a plug:
  • Connect the green wire to the pin with the bent tab
  • Connect the white wire to one of the pins directly left or right of the bent tab
  • Connect the black wire to the other pin directly left or right of the bent tab
  • Screw down the wire contacts on to the bare electrical wire only and do not clamp down on the insulation of the wire. Bad contacts cause sparking which may cause the cord to heat up and may damage equipment.

Making an Extension Cord:
  • Use a 12 Gauge or thicker cable if you plan to make a 100 ft or longer extension cord

Generator Instructions:
  • Equipment must be switched off before turning the generator on or off
  • When using a generator make sure the plug is wired for A/C
  • Recommended Generator Size:
    • COMET: 4,000W
    • UNIDRIVE: 5,000W
    • UNIFLOOR: 5,000W
    • UNIPLAN: 7,000W

Comments are closed.
STANMECH Technologies Inc. 
944 Zelco Drive Burlington ON L7L 4Y3 | 1-888-438-6324 | 
info@stanmech.com
Terms of Use    Privacy    Terms and Conditions of Sale   Warranty Policy
Français

Proud Member of:
Picture
Industrial Fabrics Association International
Picture
International Association of Geosynthetic Installers
Picture
​Authorized by the Association of Professional Engineers of Ontario to offer professional engineering services. 
  • Home
  • Equipment
    • All Equipment >
      • Air Heaters
      • Automatic Equipment
      • Blowers
      • Extrusion Welders
      • Hot Air Blowers
      • Hot Air Hand Tools
      • Testing Equipment
    • Flooring
    • Geomembrane
    • Industrial Fabrics
    • Manufacturing
    • Plastic Fabrication
    • Roofing & Decking
  • Services
    • Product Selection Help
    • Engineering Help
    • Installation Support
    • Product Training
    • Product Service
  • Resources
    • Articles
    • Case Studies
    • Engineering Information
    • Operating Manuals
    • Tech Tips
    • Whitepapers
  • About Us
  • Contact
    • Contact Us
    • Find a Distributor
  • Français